Skip to Content

100
JBL MS-A5001 - Mono Amplifier

JBL-MS-A5001

JBL MS-A5001 - Mono Amplifier

£499.99

BL's stylish MS Series "Tiny" amps measure only 7" by 8" so you can tuck one into virtually any hiding place that has adequate ventilation. Or you can mount one in a prominent spot to show off the bright digital display with its tone and gain settings. These unique amps come with a setup CD and include built-in indicators that help you set the input level perfectly. They also feature preamp and speaker-level inputs so you can hook them up to almost any system.

Digital signal processing
The MS-A5001 sends 500 watts RMS to your sub at either 2 or 4 ohms. Digital processing makes tuning this amp virtually a snap. It offers a wide selection of crossover points and gives you a choice of three filter slopes to get just the right tone to your music's bass.

Sophisticated circuitry
An optional remote bass controller does much more than just turn this amp up and down. This wireless controller works with multiple MS Series amps at the same time, coordinating the low frequencies of all the amps to blend smoothly so you don't get a bunch of mud when you boost the bass. A signal-sensing turn-on circuit eliminates the need for a separate lead from your receiver, and a special input mode allows this amp to work even when there's a factory amplifier in your car's system.
Optional remote level bass control available (MS-WBC)

  • MS SERIES SYSTEM INTEGRATION DIGITAL PROCESSOR / AMPLIFIER.
  • PRE-ORDER NOW FOR DELIVERY IN MID-SEPTEMBER
  • Mono subwoofer amplifier
  • 500 watts RMS x 1 (2 to 4 ohms)
  • CEA-2006 compliant
  • Selectable high- and low-pass filters (20-140 Hz; 6, 12, or 24 dB/octave)
  • Optional wireless remote bass controller (automatically pairs with multiple JBL MS amps - MS-WBC)
  • Class-D amplifier design
  • Digital signal processing — settings stored in non-volatile memory, no settings lost if power is disconnected
  • Speaker-level inputs (RCA adapters included)
  • "Hi2" input setting provides factory system amps with output loads, eliminating "speaker disconnected" error messages
  • CD for system setup included
  • Preamp inputs and outputs
  • Output level controls
  • fuse rating: 40A x 2
  • 8-gauge power and ground leads and an 80-amp fuse recommended — wiring and hardware not included with amplifier
  • 7-3/16"W x 2-3/4"H x 8-1/4"D